Blog
Cycloid reducer is more prone to failure
Release time:
2021/03/11
cycloid reducerBecause this kind of equipment is usually used for a long time, various problems sometimes occur. However, most of the faults can be handled by themselves and do not need the maintenance of professional masters. If you want to repair yourself, you also need to have certain experience and knowledge. The following is to give you a list of cycloid reducer is more prone to failure, the specific should be how to deal.
One: gear wear
Forcycloid reducerBecause of the high frequency of rotation, gear wear is a common fault. The advice to you is that you should try to give the machine time to rest, not always 24 hours of non-stop operation. The other is that if it is found that the gear has been worn seriously, it should be replaced in time to avoid affecting efficiency.
Two: oil leakage
cycloid reducerOil leakage is generally caused by two reasons, one is because the plug is not tightened after the oil change is completed, so that leakage occurs during the high-speed operation of the equipment is normal. This situation is not a fault, as long as the plug is tightened. The other is because the machine has been used for too long and has been severely worn. The oil leakage caused by this has no way to deal with it. It must be repaired by a maintenance master.
In addition to the above two points, the cycloid reducer will have some other faults when in use. For example, if there is abnormal noise or noise, you can see if the machine is not flat, or listen to if there is any small stone inside. If you can't find the problem, it is suggested to turn off the equipment and find a master to help solve it.
Latest information