Blog
Parameter characteristics and installation precautions of S series reducer
Release time:
2022/09/08
Each product is strictly inspected with a decibel meter when it leaves the factory. Each S series reducer needs to pass through the energized forward and reverse testing machine for 30 minutes before painting, thenS series reducerWhat are the parameter characteristics and installation precautions?
1. Under the same reduction ratio, it is 10% to 15% higher than the worm gear reducer. That is, they are on the same device. The R series helical gear reducer is more energy-efficient and its motor power is smaller.
2. Input and output 90 degrees, also called straight hand shaft reducer. S series reducer is generally composed of a pair of helical gears and a pair of worm, so it is also called helical gear worm reducer. The large output torque available is much greater than that of the RV series worm reducer.
3. There are various output modes, including hollow shaft, solid shaft, spline shaft output, etc.
4. Similarly, the efficiency is higher than RV series snail and lower than other helical gear reducers, which can achieve local self-locking.
5. The input forms of S series reducer include circumferential input, shaft input and extended worm shaft input
6. The output form has the small hole output, the one-way shaft output and the two-way shaft output. On this basis, the S series reducer worm speed 1400rpm. If the equipment is special, the manufacturer may be required to customize the non-standard machine with a center distance of 25, 30, 40, 50, 50, 63, 75, 90, 110, 130, etc. Can also be customized.
The installation of S series reducer is
1.S series reducer can be installed in a variety of forms, six planes can be installed.
2. The installation position must be firm and reliable.
3. The error range cannot be greater than the allowable tolerance.
4. After installation, it must be flexible and not stagnant.
Under normal circumstances, the working environment of the S series reducer is between -40 degrees Celsius and 40 degrees Celsius. If it exceeds this range, contact the reducer manufacturer.
Previous Page
Next Page
Previous Page
Next Page
Latest information