Blog
Four series of reducer manufacturers to tell you about the use of worm gear reducer matters needing attention
Release time:
2021/12/09
Four series reducerManufacturer: Worm gear reducer daily use matters needing attention
1. Select the installation position of the worm gear reducer. If the location allows, try not to use vertical installation. Vertical installation, the amount of lubricating oil is far more than the horizontal installation, easy to cause the reducer heat oil leakage.
2. The choice of lubricating oil and additives, worm gear reducer generally use gear oil. For heavy-duty, frequent start-up, poor use of the environment of the reducer, can choose some lubricating oil additives, so that the reducer to stop running when the gear oil is still attached to the surface of the gear, forming a protective film to prevent metal in heavy load, low speed, high torque and direct contact when starting. The additive contains a sealing ring regulator and an anti-leakage agent, which can keep the sealing ring soft and elastic and effectively reduce the leakage of lubricating oil.
3. In order to ensure the assembly quality, you can buy or make some special tools. When disassembling and assembling worm gear reducer parts, try to avoid knocking with hammers and other tools; when replacing gears and worm gears, try to use original parts and replace them in pairs; pay attention to tolerance coordination when assembling the output shaft; the hollow shaft should be protected with anti-adhesive or red Dan oil to prevent wear, rust or scaling in the matching area, and it is not easy to disassemble during maintenance.
Four series reducer manufacturers: What should I do before using worm gear reducer
Clean the machine shaft before using the machine. And check whether there are scratches or dirt on the device shaft, if there is, thoroughly remove and clean. The working temperature of the reducer is 0~40. Check whether the matching size of the hole (or shaft) connected with the reducer meets the requirements. Before operation, replace the blockage at a high position with an exhaust plug to ensure that the gas in the body is discharged when the reducer is running.
Four series reducer manufacturers: the use of worm reducer matters needing attention
Be careful when using any machine, especially precision machines like worm gear reducers. When installing the worm gear reducer, it must be firmly installed on the machine and must not be loose. In this process, it is necessary to confirm whether the steering of the reducer is correct, and then the installation operation can be carried out intermittently.
If the reducer is placed for too long and the oil seal is not immersed in the lubricating oil after 3 to 6 months, it is recommended that the reducer user replace the oil seal. According to the operating rules of the reducer, the temperature of the standard working environment is -5 to 10 degrees. If this rating is exceeded, contact the manufacturer. Reducers are usually used with reducer motors or motors, so ventilation devices need to be installed to improve heat dissipation and maintain normal operation.
When installing and using the worm gear reducer, you must first check the lubricating oil level. It is not recommended to immediately raise the load to a very high level, but it is recommended to increase it gradually, and install a protection device around the worm gear reducer to avoid losses caused by external collisions.
Latest information