Blog
Analysis of Common Problems in the Installation Process of Cycloid Reducer
Release time:
2021/08/11
cycloid reducerIt is composed of three parts, namely the input, output and deceleration parts, which together form a complete transmission device. Generally, the volume is relatively small, the structure is compact, and the reduction ratio is large. Because the equipment can help maintain the stable performance in operation, it is widely used, such as chemical industry, mining, medical industry and other industries. It has a unique operation mode. In order to improve the service life of the equipment, to reduce the production cost input to a certain extent, it is necessary to carry out regular maintenance and maintenance according to the characteristics of the equipment, and at the same time take emergency measures to find and solve the fault in time. However, sometimes due to production conditions, installation problems, on-site conditions and other reasons, in the actual use process, some problems are often encountered, which require the relevant staff to pay more attention, and can fully reflect the advantages of the cycloid reducer, thereby improving work efficiency.
cycloid reducerAnalysis of common problems during installation
The cycloid reducer itself is small in size and easy to connect between equipment. However, due to the existence of various forms of connection, there are many details to pay attention to in the installation to ensure the normal operation of the cycloid reducer and other equipment. Mainly from the following four aspects of analysis:
(1)cycloid reducerThe output shaft in the output device can withstand limited axial impact force. It is not advisable to use the shaft end spiral for installation, use the screwing method to nail and press the joint, and directly hammer the reducer.
(2) During installation, it is necessary to ensure that the corresponding size of the reducer is highly compatible, including the standard and horizontal height of the installation center line, to ensure that the concentricity of the reducer is within the strict standard range.
(3) In the rotation of the lubrication system of the equipment itself, the actual working environment of the reducer should also be fully considered, and the oil pump has production requirements to meet the lubrication of each part of the reducer.
(4) To ensure that the appearance of the reducer does not deform during the installation process, provide a horizontal working position, and arrange the bolts of the cushion block symmetrically. In addition, in order to prevent the reducer from leaking oil during operation, the inclination angle of the reducer is required to be controlled within 15 degrees during installation.
Latest information