Blog
Planetary reducer how to install only specification?
Release time:
2021/05/11
planetary reducerMore and more popular, many friends who have used it are very clear about its installation, and some friends who have come into contact with it for the first time are very unfamiliar with how to install the planetary reducer. So today, the planetary reducer manufacturer will introduce the correct installation method for the first time.
1. Before installing the planetary reducer, we first need to check whether the motor and the reducer are good or not. And confirm whether the holes connected between them are correct and can be matched.
2. Before installation, it is also necessary to wipe clean the input shaft of the motor and the connecting part between the boss of the motor and the reducer with specific engine oil or zinc water specially used for cleaning.
3, in the motor andplanetary reducerBefore connecting, the keyway of the shaft of the motor must be perpendicular to the tightening bolt. Its function is to ensure that the force can be evenly applied during use. And install any diagonal position in advance, but you can't tighten it first, then install bolts at the other two diagonal positions, and then tighten the screws between the four corners one by one.
During the installation process, the motor and the reducer should be naturally connected. The concentricity of the output shaft and the input shaft of the reducer must be consistent, and the flange is also.
5. During the installation process, it is not allowed to knock the reducer to avoid damage.
6. Removeplanetary reducerScrews on the dust holes on the outside of the flange are used to adjust the clamping ring of the system so that the side holes can be aligned with the dust holes. Then tighten it again, then take down the shaft key, and then tighten all the bolts. No loosening can occur.
Latest information